| Power Pack - For VMA-T210X Twin Otter - Contents |
This VMAX Power Pack (#VMM-T210XPP1) contains the following:
|
| Wiring Harness Set - For VMA-J210X JU52 Trimotor - Contents | This VMAR Wiring Harness Set (WHS) contains the following
- Aileron Wiring Harness (WHA) to connect the two aileron servos in the wings to the aileron channel of the receiver in the fuselage. Total Length = approx 32 in. (813 mm). Length from aileron channel connector to Y = approx 7 in. (178 mm)
- (Note: The aileron wiring harness does NOT provide for flaperon operation using a computer radio and two discrete receiver channels. VMAR models utilizing two aileron servos will usually support computer radio flaperon functionality in conjunction with the aileron wiring harness if additional aileron extensions are purchased in addition to the aileron wiring harness included with the wiring harness set).
- Throttle Wiring Harness (WHT) to connect three Electronic Speed Controls (ESC) to the throttle channel of the receiver in the fuselage. Total Length = approx 12.5 in. (318 mm). Length from throttle channel connector to Y = approx 6 in. (152 mm)
- Power Wiring Harness (WHP) to provide Positive (+) and Negative (-) power to three motors from a single battery (fused in line). Total Length = approx 14 in. (355 mm). Length from battery connector to quick disconnect joint = approx 5.0 in. (127 mm)
This VMAR Wiring Harness Set also contains:
- Flap Wiring Harness (FHE) to connect the flap servos located in the wing (inboard locations) to the flap channel of the receiver in the fuselage. Total Length = approx 22.5 in. (571 mm). Length from flap channel connector to junction = approx 7 in. (178 mm)
-
End User Wiring Labels
|
| Power Module - For VMA-T210X Twin Otter - Contents | This VMAX Power Module (#VMM-T210PM1) contains the following
- Two power pylons, each consisting of:
- Laser cut wood power module firewall assembly (#VMA-T210XPMV)
- Brushless Motor (#VMM-111B18VM)
- Propellor mounting hardware
- Electronic Speed Control (ESC) (#VMC-120B15VC)
- Wiring between the Motor and the ESC
- Wiring leads from the ESC to provide Positive (+) power, Negative (-) power and throttle control
- All components have been factory installed, connected & tested.
- Crimp on bullet connectors (female) for the ESC power feeds (2 Red, 2 Black)
- Documentation
|
|
|
|
|
|
|
|
| Article ID: 6832 |
