After aligning the engine mount T-beam mounting holes, you are ready to install the engine mounts.

 

Use four hex head 4mm bolts with washers under the heads. Insert the bolts through the firewall from the backside of the firewall. Position the T-beam mounts as shown in Pictures 14D and 15A in the Assembly and Operations Manual.

 

Loosely screw all four bolts through the firewall and though the T-beams and into 4 mm nuts before tightening any one bolt or nut. Once all bolts are inserted through firewall and the T-beams and engaged with the 4mm nuts, tighten the bolts and nuts snugly. Ensure the washers on the back side of the firewall sink down into the counter sink holes so that the outer surface of the washers are flush with the back surface of the power module firewall. Wait for 1 hour and then apply Pacer Z42 Blue Threadlocker to the nuts and the threads near the nuts. Retighten the bolts snugly.

 

Engine T-beam Mounts Installed - Back View	Engine T-beam Mounts Installed - Front View