a) Review the Read Me First documentation and the Assembly & Operations Manual that came with your model.

 

b) Not Applicable

 

c)  Complete Stage 1 from the Assembly & Operations Manual.

 

d) Complete Stage 2 from the Assembly & Operations Manual. Note that in some markets the power pylons have been pre-attached to the wing by the factory.

 

e) Once you completed Stage 2 from the Assembly & Operations Manual you will have an assembled wing with power pylons attached to the wing.

 

f) Complete Stages 3 to 8 from the Assembly & Operations Manual.

 

g) Review Stage 9 of the Assembly & Operations Manual. In particular consult figure 9I of Assembly and Operations Manual. We suggest that in lieu of Figure 9I that you instead arrange the two wing ESC's as follows:

 

h) See Figure 2A. Note the orientation and position of the two speed controls. In particular note that the ends of the ESC with the motor power wires are partially positioned into the wing bay cavity adjacent to the large open cavity at the center of the wing.

 

 

i) You will find a wooden block with a slot, zip strapped to each wing ESC. AFTER installing all wiring and before flying your model, use ZAP-A-GAP or ZEPOXY to attach the blocks to the floor of the large cavity at the center of the wing, oriented and positioned as shown in Figure 2A. If you need to remove the ESC's at a later date you can cut the zip strap to remove the ESC and then re-install the ESC using a new zip strap.