ArticlesArticles Most Popular ArticlesMost Popular Articles Most Helpful ArticlesMost Helpful Articles Submit A QuestionSubmit A Question Login for PRIORITY RESPONSELogin for PRIORITY RESPONSE
RSS Feeds
DrillDown Icon Table of Contents
DrillDown Icon LIABILITY & COPYRIGHT
DrillDown Icon Site Information
DrillDown Icon * Support
DrillDown Icon Technical Info - Adhesives
DrillDown Icon Technical Info - Master Airscrew
DrillDown Icon Technical Info - POLYPRO
DrillDown Icon Technical Info - RC Flying - General
DrillDown Icon Technical Info - RC Flying Electric - General
DrillDown Icon Technical Info - ULTRA POWER Technology - Products
DrillDown Icon Technical Info - VMAR - General
DrillDown Icon Technical Info - VMAR - Products
DrillDown Icon Technical Info - VMAX Electric Power Systems - General
DrillDown Icon Technical Info - VMAX Electric Power Systems - Products
DrillDown Icon Technical Info - VMAX Engines (Glow) - General
DrillDown Icon VMAX Engines - Documents
DrillDown Icon Engine Bearings - Replace or Not?
DrillDown Icon Engine Piston & Sleeve - Replace or Not?
DrillDown Icon After Run Oil - Why use it?
DrillDown Icon Engine Carburetor - Spray Bar - Alignment
DrillDown Icon Engine Carburetor - Rotor Difficult to Rotate
DrillDown Icon Engine Carburetor - Low Speed Mixture - How to Set?
DrillDown Icon Engine Carburetor - Will not shut off.
DrillDown Icon Engine Cleaning - How to Do It?
DrillDown Icon Engine Dimensions (Sizes)
DrillDown Icon Engine Head Bolts - How Tight?
DrillDown Icon Engine - Inverted Operations
DrillDown Icon Engine OK on Ground - Poor in Flight
DrillDown Icon Engine Power - What is Appropriate?
DrillDown Icon Engine Prop Size?
DrillDown Icon Engine (ABC type) - Clyinder (Sleeve) Removal
DrillDown Icon Engine (ABC type) - Crankshaft Removal
DrillDown Icon Engine (ABC type) - Piston Removal
DrillDown Icon Engine (ABC type) is Tight at Top Dead Center - Is something wrong?
DrillDown Icon Engine Storage - Preparation
DrillDown Icon Engine Types and Power Considerations
DrillDown Icon Rust - How to Remove It?
DrillDown Icon Rust - Why is it Bad? How to Prevent It?
DrillDown Icon Technical Info - VMAX Engines (Glow) - Products
  Email This ArticlePrint PreviewPrint Current Article/Category and All Sub-Articles/Categories
 
Engine Storage - Preparation - Strongly Recommended

Question: I am not planning on using my engine for a period of time. What should I do before stroring it?

Answer: Remove all methanol from the Engine. Apply a generous amount of After Run oil. Turn the engine over by hand to ensure the After Run Oil works its way to all components. Seal the engine in a plastic bag.

Better Answer: Remove the glow plug and carefully put 6-10 drops of Afterrun Oil (Pacer After Run recommended) into the combustion chamber and another 6-10 drops into the carburetor inlet. Turn the engine over by hand 10 times. Do this a second time...  apply another 6-10 drops of After Run Oil into the carb inlet and combustion chamber... turn the engine over by hand 10 more times. Finally put the engine into a plastic bag, squeeze the air out of the bag and seal it.

 

Article ID: 2730