ArticlesArticles Most Popular ArticlesMost Popular Articles Most Helpful ArticlesMost Helpful Articles Submit A QuestionSubmit A Question Login for PRIORITY RESPONSELogin for PRIORITY RESPONSE
RSS Feeds
DrillDown Icon Table of Contents
DrillDown Icon LIABILITY & COPYRIGHT
DrillDown Icon Site Information
DrillDown Icon * Support
DrillDown Icon Technical Info - Adhesives
DrillDown Icon Technical Info - Master Airscrew
DrillDown Icon Technical Info - POLYPRO
DrillDown Icon Technical Info - RC Flying - General
DrillDown Icon Technical Info - RC Flying Electric - General
DrillDown Icon Technical Info - ULTRA POWER Technology - Products
DrillDown Icon Technical Info - VMAR - General
DrillDown Icon Technical Info - VMAR - Products
DrillDown Icon Technical Info - VMAX Electric Power Systems - General
DrillDown Icon Technical Info - VMAX Electric Power Systems - Products
DrillDown Icon Batteries
DrillDown Icon Battery Chargers
DrillDown Icon Motors - Brushless
DrillDown Icon Power Module Set (Electric)
DrillDown Icon Overview
DrillDown Icon Typical Contents
DrillDown Icon Propeller Mounting
DrillDown Icon For VMA-B210X Bird Dog
DrillDown Icon For VMA-C210X Cub & L4
DrillDown Icon For VMA-D210X DO27
DrillDown Icon For VMA-J210X JU52 Trimotor
DrillDown Icon For VMA-N210X Nouvo
DrillDown Icon For VMA-P210X PC9 & Texan II
DrillDown Icon For VMA-S210X Aero Subaru
DrillDown Icon For VMA-T210X Twin Otter
DrillDown Icon More Information
DrillDown Icon Tools
DrillDown Icon Power Packs (Electric)
DrillDown Icon Power Supplies
DrillDown Icon Wiring Harness Sets
DrillDown Icon Technical Info - VMAX Engines (Glow) - General
DrillDown Icon Technical Info - VMAX Engines (Glow) - Products
  Email This ArticlePrint PreviewPrint Current Article/Category and All Sub-Articles/Categories
 
Tools for Power Modules & Power Packs
A screw driver and a pair of pliers is about all you need to install most VMAX Power Modules & VMAX Power Packs.

For those looking to make things go a bit faster and a bit easier here are some tools that help with the installation:
  • Medium Phillips (cross head) screw driver. Regular Length. A short stubby length may also come in handy
  • A 7/32 in. "deep" socket for the 3mm nuts on the 4 mounting bolts. The 3mm nuts are used for most of our smaller electric ARF's.
  • If you need to ream out (drill) any mounting bolt holes in the power module firewalls, a 9/64" drill bit works well. This allows slightly easier installation of the power module firewall onto the fuselage 3mm stud bolts and/or the slightly easier installation of the motor mount bolts (usually factory installed so not likely necessary in the field).
 
 
Article ID: 6330