Wiring Harness Set - For VMA-T210X Twin Otter - Introduction
 
 
Before beginning the Installation Instructions please read the Overview and check off the components provided. Each component is in a labelled parts bag. Please check off the components against the Contents list below. Leave the components in their parts bags for now. Do not remove the components from their parts bags until each is needed during the installation process. 
 
Wiring Harness Sets - For VMAR Power Packs - Overview
VMAR Wiring Harness Sets for VMAR Power Packs contain all of the wiring and connectors to install and operate the components of multi-motor VMAR Power Packs and any servos included with the power pack. (Note: Single motor power systems include discrete wiring components and do not use a wiring harness "set" per se.)
 
VMAR Wiring Harness Sets are factory designed to fit into the applicable VMAR model with its applicable VMAR power system and any included servos. All of the connectors have been factory installed. 
 
VMAR Wiring Harness Sets are:
  • Included with VMAR Power Packs for the applicable model.
  • Available as a stand alone accessory for use with VMAR Power Modules for the applicable model.
  • Provide for fast and reliable installation of VMAR Power Packs and Power Modules into VMAR multi-motor electric models. 
    • Note: Modelers who are not experienced with multi-motor electric flight systems are strongly encouraged to use the VMAR Wiring Harness Set applicable to their VMAR multi-motor model. Scratch building and installing a reliable wiring harness set for a multi-motor electric model requires approximately 8 hours of work & considerable knowledge and experience.
  • May be suitable for use with some third party power systems and servos supplied by end users.